Assignment: make a FabISP in-circuit programmer; make IDC ISP cable.

I took the available traces from the FAB Academy website, sent the images to the Modela, made sure all dimensions were correct, and milled my board. I eventually milled my board twice because my dimensions for the first made the bit go off the board (20,20). I changed my dimensions to (20,15) and it seemed to work pretty well.

EPB EPT

EPb

Above are the images of my FabISB and FabIDC. Once I successfully soldered my board, I connected it to my computer in order to program it. As given in the class website tutorial, I set up my development environment for my board by downloading WinAVR and firmware. From there, I edited the Make file, then made hex, fuse and program.